When the LED stops blinking, your listener has reset. Press and hold the Setup button for about 10 seconds. Press and hold the Connect Button (located on the side of the device) for 10 seconds until the LED Ring blinks once, then release the button. Press and hold the setup button (located on the side of the device) with the battery in, until the LED stops flashing (approximately 10 seconds) Press and hold the setup button (located inside the device) with the battery in, until the LED stops flashing (approximately 10 seconds). NOTE: The device will not remain awake after resetting and will go into standby mode. If the device is powered up with the test button held down for 10+ seconds, the device will reset all Z-Wave settings and leave the network. Please contact Customer Support for assistance if you're having difficulty with your Ring Alarm.įactory Reset your First Alert Smoke & CO Detector
Range Extender (1st generation) and (2nd generation)ĭo not attempt to factory reset your Ring Alarm Base Station without guidance and support from a trained Ring Customer Support expert. Silversun Pickups all, Official, Chords, Tabs, Pro, Power, Bass Tabs, Drum Tabs, Ukulele Chords tabs including panic switch, well thought out twinkles, lazy eye, booksmart devil, circadian rhythm. If you ever get stuck while troubleshooting your Ring Alarm devices and need to factory reset any of them (as a last resort), you can use the instructions below:
